ADL-01- ARTNET – 2 X 170 CH Artnet / SPI

The MODUS ADL-01 ARTNET 2CH SPI LED Digital Strip is a digital LED driver with ArtNet protocol support.
It is powered by safe voltage from 12-24VDC range. It has external power input or can be powered by Passive POE.
It is ideal for controlling digital LED strips and digital LED modules in a permanent installation.
The unit has 2 independent outputs with up to 170 RGB pixels on each output.
With a flat housing, we can mount the driver near the controlled LEDs.
The applied system of standard RJ45 connectors for Ethernet and disconnectable screw connectors for power input and output to the LEDs facilitates installation and later operation.
The device has been equipped with protection against reverse polarity of the supply voltage and overload.
They protect not only the converter but also the controlled LEDs from damage.
The converter operates in LAN and is controlled by the popular ArtNet protocol. It works with a dedicated MODUS DevManager software, so that all the configuration is done remotely over Ethernet network. It’s an ideal solution when the device is mounted in hard to reach places.
The module has Data and CLK signal outputs and works with digital LEDs powered from 5V, 12V and 24V.
It supports 6 types of digital LEDs: APA101, APA104, TM1803, TM1804, TM1809, TM1812

Technical parameters
– Connection : 2x output for digital LED modules (DATA and CLK signal)
RJ45 (Ethernet, ArtNet)
Power supply input
– Power supply: 12-24V DC, 200mA
Passive PoE or power connector- Dimensions: 67x68x25 mm (without connectors), 67x86x25(with connectors)

– Supported chips: APA101, APA104, TM1803, TM1804, TM1809, TM1812
– Configuration using DevManager software.

The manufacturer reserves the right to make changes in functioning and operation of the device in order to improve the product